Maintenance Method Of Gas Range

               Igniter does not produce sparks natural ignition of the piezoelectric ceramic machine does not produce sparks, so that the stove plate can not be angry. This kind of fault is mainly by the automatic switch to the piezoelectric ceramic positive electrode due to the destruction and open circuit, can be used to reconnect wire reliable connection. In addition, if the piezoelectric ceramic cathode (both metal rods) contaminated or rust caused by bad contact, will also cause ignition difficulties, at this time can be extracted metal rods, with fine sandpaper wipe dirt after insertion.

               There is a spark but can not ignite sometimes piezoelectric ceramic anode and the distance between the anode electrode is too far or too close, will make the spark can not ignite gas, should adjust the distance to 4 millimeters. In addition, near the igniter side of the gas nozzle is the benefit of the material or other foreign bodies blocked, will also cause the point does not fire or ignition difficulties, as long as the removal of the nozzle inside the blockage can be.Gas Range

                1, the total gas source switch is not open, open the gas source total switch 2, battery power is insufficient, replace the battery 3, the ignition needle grease more; clean ignition needle grease 4, the ignition needle position is improper, adjust ignition needle and fire cover of distance 4-6mm, and aim at fire Hole 5, fretting switch is bad, professional replacement 6, induction needle short circuit, adjust induction needle not contact with fire cover.Gas Range

                1, rubber tube aging rupture or fall off, replace or reconnect hose 2, the main fire of the furnace is not ignited, accidental flameout, to be exhausted after the ignition of the gas after 3, into the trachea sealing aprons aging, change the rubber ring.Gas Range